What are the key points for daily maintenance of welding fume dust collector?

What are the key points for daily maintenance of welding fume dust collector?

When using a Nissan welding fume purifier, routine maintenance is required. Only in this way can the equipment operate normally and safely for a long time. So what are the key points of daily maintenance of the welding fume dust collector?

What are the key points for daily maintenance of welding fume dust collector?

1. Managers should be familiar with the performance and usage conditions of the dust collector, and master adjustment and maintenance methods.

2. Regularly measure process parameters, such as gas volume, temperature, concentration, etc. If an abnormality is found, the cause should be identified and dealt with promptly.

3. Mechanical moving parts such as reducers and ash conveying devices should be filled with oil and changed according to regulations, and any abnormal phenomena should be eliminated in time.

4. If the electromagnetic pulse valve fails, it should be eliminated in time. If there are impurities and moisture inside, clean them. If the diaphragm is damaged, it should be replaced in time.

5. When the machine stops, there is no need to cut off the compressed air source, especially when the fan is working. Compressed air must be supplied to the lift cylinder to ensure that the poppet valve opens.

6. When the dust collector is working normally, the ash discharge device cannot stop working, otherwise the ash hopper will soon be filled with dust and overflow into the bag chamber, forcing the dust collector to stop working.

7. When starting up, you should first open the compressed air tank, turn on the control power, and start the ash discharge device. If there are other devices in the system, you should start the downstream device first.

8. The oil-water separator in the gas storage tank and gas supply triplet should be discharged once every shift, and the oil-water separator should be cleaned every 3 to 6 months. The oil mist injector should be checked frequently for oil storage and refueled in time.

9. When using a scheduled cleaning controller, it is necessary to regularly measure whether the cleaning cycle is accurate, otherwise it should be adjusted. When using a constant resistance pulse controller, regularly check the working condition of the pressure switch, check whether the pressure measuring port is blocked and clean it.

10. When the machine is shut down, and after the process system is shut down, the central welding fume purifier and exhaust fan should continue to work for a period of time to remove moisture and dust in the dust removal equipment. It must be noted that when the dust collector stops working, the dust collector must be cleaned repeatedly

11. Manual dust removal can be used, and the dust on the dust removal filter bag must be removed to prevent the filter bag from being affected by humid gas.

For the long-term use of welding fume dust collector, later maintenance is very important. Only by mastering these necessary skills can the smooth use of the equipment be guaranteed.

The above is the relevant knowledge compiled by the editor for you. Now, we have a welding dust collector at home. I also have a few installed at home. However, for those who have a lot of space in their home, a vacuum cleaner is a suitable option. After all, it is very convenient to use, and most of them are used on factory smoke exhaust buttons. Hope this helps!